HomeContact usBlogMobileSitemap
     
 
     
브랜드list


ㆍHOME > ㆍ취급제품 > ㆍMaker > ㆍCom-Power


분 류 Telecom Test System
Link#1 Part68Test%20Equipment.html (Down:1454)
TELECOM TEST STATION (FCC Part68, Industry Canada CS03)

TELECOM
TEST STATION (FCC Part68, Industry Canada CS03
)

SG-168 (model)
Surge Generator, Type A/B (description)

LB-168
Longitudinal Signal and Balance set

IS-268
Impedance test set

RS-368
Ringer Set

LS-468
Loop Simulator

DB-568
Digital Service Balance Set

LS-668
Loop simulator for 26 AWG cable

TS-568
Complete test station (All of the above)
 
 
 
 
 
 
 
 
 
Telecom Test System
 
Complete System
Surge Test
Balance Test
Signal Power Test
On Hook Impedance Test
Billing Protection Test
ROLR Test

Telecom Test System for TIA-968 Testing
Com-Power's Telecom Test System is designed to perform testing according to TIA-968 technical requirements for connection of terminal equipment to the telephone network (formerly FCC Part 68). Please visit the following links to read more about the specific requirements for this test.

Administrative Council for Terminal Attachments and Industry Canada CS03.
This system contains most of the specialized circuitry needed to perform testing on analog modems and analog telephones. Generic third party equipment for may be needed to perform some of the tests.
Surge Generator (Model SG-168A)
The Model SG-168A Surge Generator is designed for applying high voltage surges to equipment connected to the telephone network.  The SG-168A Surge Generator is capable of performing telephone line surge type A and type B per TIA-968 and Industry Canada CS03 requirement.  
Longitudinal Signal Power and Balance ( Model LB-168)
The LB-168 is capable of analyzing Longitudinal Signal Power and Longitudinal Balance of telephone interface devices. Longitudinal Signal Power measurement is required due to the great distance telephone lines cover. Balance measurement is required because Telephone networks may use complex multiplexing schemes to comunicate from one central office to another thus limiting cross talk between lines. Please see application table below.
Impedance Test Set (Model IS-268)
The Impedance test set model IS-268 is designed to analyze AC and DC on-hook impedance of a telephone interface device. These impedances during ringing tests, were designed to protect the telephone network from excessive current flow while on-hook.
Ringer Set (Model RS-368)
The Ringer set model RS-368 is capable of supplying the ringer voltage for the on-hook impedance and billing protection testing.
Loop Simulator Test Set (LS-468)
The LS-468 is a two-wire loop simulator. It is designed to simulate the full range of voltage, current and AC impedance parameters normally encountered when connected to the telephone network.
Digital Service Longitudinal Balance (Model DB-568)
DB-568 is designed to analyze longitudinal balance of terminal telephone equipment that use digital service.
Loop Simulator for 26 AWG (Model LS-668)
The model LS-668 Loop Simulator 26 AWG cable was constructed to meet the requirement for testing analog telephones, under the "Receive Objective Loudness Rating" (ROLR).
 



CEO인사말 취급제품 견적문의 뉴스&공지사항